Maintenance; Software Management - Mitel CPDM3 Installation Manual

Installation Guide

7. MAINTENANCE

7.1 SOFTWARE MANAGEMENT

7.1.1 INSTALLATION OF SOFTWARE
Normally the installation of software is done from the product's web interface but it can
also be done in Boot Mode, see
7.1.2 CREATE BACKUP OF SOFTWARE SETTINGS
Normally the backup is done from the product's web interface but it can also be done in
Boot Mode.
Set the product in Boot Mode, see
1 Select Software > Install software.
2 Click "Backup". All settings for last run software will be saved.
3 Click "Save" in the File Download window.
4 Select where to save the file and click "Save" again.
7.1.3 FIELD UPGRADE OF BOOT SOFTWARE
By using a USB memory stick with a Boot software (autoupdate.bin), the product can
be upgraded on the field.
1 Insert the USB memory stick in the upper USB connector marked 1.
2 Perform a controlled restart via the Restart button, by pressing the button and
releasing it within 4 seconds.
The Status LED indicates shutting down with quick flashing blue light
Before starting up again, the Status LED will indicate "waiting" for one minute
with flashing yellow light
3 When the Status LED indicates starting up with quick flashing blue light
The Mode button should indicate by showing fixed blue light
The module now detects the memory stick and begins the upgrade process which is
indicated by the Status LED with fixed yellow light
takes 7-8 minutes.
After the upgrade process has finished, the product will continue and start up the last
used software. The complete operation can take up to 10 minutes.
To verify a successful upgrade, you can put the USB stick back in your computer and
open the file autoupdate.log. In the end of that file, you should then see the text
"Upgrade finished successfully".
NOTE: If the USB memory stick contains faulty Boot software, the module will start up
in Boot Mode.
34/1531-ANF901 43 B1 2016-03-31
5.1.3 Install Software in Boot Mode
5.1 Set Product in Boot Mode
, press the Mode button within 3 seconds.
.
. The upgrading process
TD
on page 26.
on page 25.
.
.
29