Upgrade System Software - Mitel UC360 Administration Manual

UC360 Administration Guide

Upgrade System Software

You have several options for upgrading the system software as new software loads from Mitel
become available: USB flash drive, SD card or HTTP. Additionally, you can enable Auto
Upgrade, Auto Polling, and the set the Upgrade time.
Important: When upgrading from Release 1.0, it is necessary to use an SD card or HTTP
Server. When upgrading from 2.0 and up, USB Flash Drive is supported as well.
Important: It is recommended to back up the UC360 units and maintain a copy of the backup
files in a safe location.
Note: The UC360 system only supports FAT formatted USB drives. USB drives with U3
formatting will not be recognized by the UC360.
USB Flash Drive (Supported on Release 2.0 and up)
The USB flash drive must contain the file named upgrade.xml and the upgrade file package,
typically named update.zip, in the top-level folder. Mitel will supply these files with each new
software load. The upgrade.xml file name will contain the new software load version.
1. Insert the USB flash drive with the software upgrade.
2. Press Settings
3. Press System Settings.
4. Select Upgrade system S/W.
5. Select Upgrade system S/W now.
6. Select USB Flash.
You will see a series of messages. This can take several minutes; the UC360 will power
off and then on. The UC360 will reboot and load the new software.
7. Unmount the USB flash drive (see "Unmount SD Card or USB Flash Drive" on page 42)
Note: You can abort the software upgrade by pressing the Home
44
, then press Advanced.
button.