System Installation Overview; Installation Planner - Mitel 3300 ICP Hardware User's Manual

3300 ICP Hardware User Guide

System Installation Overview

To install your 3300 ICP system:
1. Install the 3300 ICP Controller
2. Configure the Controller
3. Install the Universal NSU
4. Install the R2 NSU
5. Install the BRI NSU
6. Install the Universal ASU
7. Install the ASU
8. Install the Peripheral Unit
9. Install the SUPERSET HUB
10. Install the Digital Service Unit
11. Install Wireless Devices
12. Connect the Controller to the LAN
13. Launch the System Administration Tool to program the system. (Refer to Overview of
Programming).
Tip: You can complete all of the programming without having physical connections to
the Controller. After programming you can connect units to the controller and then
power-up the system.

Installation Planner

The following required and default settings are necessary for an installation:
username
password
boot device
processor number
host name
file name
inet on ethernet (e)
inet on backplane (b)
host inet (h)
gateway inet (g)
user (u)
ftp password (pw)
114
System Administration Tool
(Default = system)
(Default = password)
Controller Configuration (RTC)
Default Settings
ata=0,0
0
/sysro/RTC8260
192.168.1.2
ftp
@
Release 3.3
Settings to
Change
IP address: subnet mask
IP address of the ftp server
Default Gateway
FTP user (installer's PC)
FTP password (installer's PC)