Install For Pri/Q.sig; Install Direct Connect Device Driver; Driver For Windows 95 And Windows 98 - Mitel 3300 ICP Hardware User's Manual

3300 ICP Hardware User Guide

Install for PRI/Q.SIG

To install and configure the 3300 Universal NSU as a PRI/QSIG variant:
1. Install a Direct Connection Device Driver on a computer.
2. Create a Dial-up Network connection on your computer.
3. Connect the computer to the 3300 Universal NSU.
4. Use the IMAT Tool to complete required PRI configuration.
5. Connect the 3300 Universal NSU to the ISDN network.
Connecting a Laptop Computer to the NSU
To connect a computer to the NSU:
1. Install IMAT. From the 3300 Software CD-ROM, run Tools/IMAT/Disk1/setup.exe.
2. Use a straight through serial cable for a direct connection.
3. Use a null modem adapter if connecting to the card through a modem.
4. If you have not already done so on the laptop computer, install a Direct Connect modem
type. You may also wish to install a modem for remote connection.
5. On the laptop, create a new Dial-up Networking entry.
Create a Modem Connection
1. Install the modem following the manufacturer's installation instructions.
2. In the Modem Properties/Advanced Settings window - Turn off error control - Turn on flow
control and select Hardware.

Install Direct Connect Device Driver

By default, Windows does not support a direct cable connection. You must add a device driver.
Windows takes the information from a Mitel file and creates the driver called NT Direct
Connection.
Refer to detailed installation and configuration instructions for:
• Direct Connection Device Driver for Windows 95 and Windows 98
• Direct Connection Device Driver for Windows 2000 Professional

Driver for Windows 95 and Windows 98

To install and configure the Direct Connection Device Driver for Windows 95 or Windows 98:
1. On the Start menu, point to Settings, and then click Control Panel.
2. Double-click the Modems icon.
3. In the Modem Properties window, click Add.
4. In the Install New Modem screen, click Other.
5. Select Don't detect my modem, I will select from a list. Click Next.
130 Release 3.3