Install 3300 Icp As A Stand-Alone Ip Gateway - Mitel 3300 ICP Hardware User's Manual

5. Open the C:\temp\symbol folder.
6. Click setup.exe.
7. Follow the instructions in the install wizard.

Install 3300 ICP as a Stand-alone IP Gateway

The 3300 ICP can be used as an IP Gateway providing the functionality of both IP and Wireless
MiNET protocols adjunct to a legacy or third party PBX connected over DPNSS or Q.Sig trunks.
Before you Begin
• Ensure that Symbol Technologies have installed and configured the Air Access Points.
• Ensure you have the ESS ID numbers of the Air Access Points.
• Install the Symbol NetVision MiNET Phone Administrator Tool on a Windows NT or Win-
dows 2000 PC.
To install as a stand-alone system:
1. Install the 3300 ICP Controller.
2. Install the System ID Module.
3. Connect power to the 3300 Controller. The controller will come up, in 15 to 20 minutes,
with factory-installed software.
4. To check the connections between the 3300 Controller and the PC:
PING the 3300 Controller IP address
FTP to the 3300 Controller IP address
Go to the 3300 Controller URL address (e.g. http://192.168.1.2).
5. Launch browser to login to the System Administration Tool (http://192.168.1.2 -- username
is system, password is password).
6. License and Option Selection form
- program number of digital links, IP device licenses and country variant.
Reboot the system.
7. Controller Module Configuration form. Select the Programmed Module Type.
8. Network Services Unit Configuration form. Set the type of NSU and the protocol to be used.
9. Program digital trunks Q.SIG or MSDN/DPNSS
10. Program Symbol Wireless phones as per instructions in System Administration Tool.
Note: You will require the ESS ID's of the Air Access Points for the configuration required
by the Symbol MiNET Phone Administrator Tool.
Note: Information on the steps requiring the Symbol NetVision MiNET Phone Administrator
Tool can be found in the tool's help system. You will be required to upgrade the Symbol
phones firmware to the MiNET protocol.
11. Perform a Backup.
12. Reboot the system.
13. Set the 3300 Controller (RTC) IP address through a communication program.
14. Install a Universal NSU.
Release 3.3
Installing
165