Mitel 3300 ICP Hardware User's Manual page 231

2. Install a Direct Connection Device Driver on a computer.
3. Create a Dial-up Network connection on your computer.
4. Connect the computer to the PRI Card.
5. Use the IMAT Tool to complete required PRI configuration.
6. Connect the PRI Card to the ISDN network.
Install a Peripheral Resource Card
Each FIM in the DSU must have a Peripheral Resource Card (PRC) installed above it.
To install a PRC in a DSU:
WARNING: Power must not be applied to the Peripheral Unit while you are installing the
Peripheral Resource card.
1. Unpack the PRC.
2. Slide the PRC into the top of slot 1 until it connects firmly with the backplane.
3. Fasten the PRC in place using the two screws provided, or use the latches on the card
guides.
4. If a second PRC is required, install it in the same manner in the top of slot 6.
Release 3.3
Install Upgrades and FRUs
223