Mitel 3300 ICP Hardware User's Manual page 247

ST (status)
L0 and L1
(on front and rear
panel)
CIM LED State Description
Off No Power
Flashing Powered On, BSP Running
On Communication Link synchronized with 3300 Controller
LED State
Green - On
Yellow - On
Red - On
Green and Yellow - On
Green and Red - On
Yellow and Red - On
Green, Yellow and Red - On
No LEDs illuminated
FIM Upper LED State
On
Off
Universal NSU Link Status
flashing
off
solid
right side - solid red
right side - off
left side - solid green
left side - flashing green
left side - off
right side - yellow
with left side - flashing green
right side - yellow
with left side - off
yellow and green alternating
between L0 and L1
yellow alternating between L0
and L1
Copper Interface Module LEDs
Message Link Controlled (Card status)
Meaning
no error
out of service
error - does not necessarily indicate total failure
out of service - this combination may occur at power-up
a fault has been detected
out of service - this combination appears at power-up
at power-up before fully operational
fully operational
Fiber Interface Module LEDs
Meaning for Local, upper and Remote, lower FIM
In frame synchronization
Power off or held in reset
Release 3.3
Troubleshooting
operational; flashing in 1/2 second
intervals
not operational
card is booting or not operating; should
be blinking in 1/2 sec intervals
no Layer 1
no error
D-channel established (PRI)
Layer 1 established (T1, E1, DPNSS)
Layer 1 established (PRI)
no link
alarm indication from far end
blue alarm from card - normal during
link startup (PRI NA or response to
yellow)
downloading (15 - 25 minutes)
decompressing and copying files (2 - 4
minutes)
239