Table of Contents
Advertisement
Getting Started
This chapter describes the steps necessary to install and set up the ZT 5085 system. It includes
instructions on unpacking, rack mounting, and making power connections.
2.1
Unpacking the System
Check the shipping carton for damage. If the shipping carton and contents are damaged, notify the
carrier and Intel. Retain the shipping carton and packing material for inspection by the carrier.
Obtain authorization before returning any product to Intel. Refer to
Support,"
Caution: Intel has designed special packing material to protect the system during shipping. It is critical that
the packing material be saved after unpacking the enclosure in case the unit must be shipped again
for any reason. Remove all boards except CMMs and those that came with the chassis before
shipment; ship these boards (and optional RTMs) separately. Shipping the unit without the original
packing material (or with boards or RTMs in the subrack) may void the warranty; in particular,
ensure that the shelf is always shipped on the pallet that came with the unit.
Caution: This system contains board-level components that must be protected from static discharge and
physical shock. Wear a wrist strap grounded through one of the system's ESD Ground jacks when
handling system components.
2.2
Shipping Contents
The ZT 5085 may be ordered as a DC or AC System. The system is shipped fully assembled and
tested. The baseline configuration and most common options are listed below. Your system may
differ from the system illustrated in this manual.
•
High Capacity 12U, 19-inch rack-mount enclosure
— 21 slot (18 node, 2 fabric, and 2 CMM) PICMG* 2.16 R1.0 packet switching midplane
— DC or AC line filters
— Two power trays
— DC or AC power input panel
•
Eight Intel
Intel® NetStructure™ ZT 6303 Hot Swap AC Power Supplies
•
Two Intel
•
Three fan trays with three blowers each
•
Air intake grill with filter
•
19 inch rack mount kit
•
Safety and compliance literature
Technical Product Specification
for assistance information.
®
NetStructure™ ZT 63134 Hot Swap IPMI Manageable DC Power Supplies or
®
NetStructure™ ZT 7102 Chassis Management Modules
Getting Started
Appendix E, "Customer
2
21
Advertisement
Table of Contents
