Configuration - Labconco Logic+ A2 Technical Manual

Configuration

After UV Lamp components are installed, you MUST reconfigure the biosafety cabinet
to enable the UV lamp.
1. From the Home Screen, press the
2. Press the [DOWN]
highlighted.
3. Press [OK/MUTE]
4. Press the [DOWN]
highlighted, then press
certifier's submenus.
5. You will see a
about to enter an area that can alter the BSC's settings;
Press [OK/MUTE]
6. When requested for the password press: [LIGHT],
[UV LIGHT], [TIMER],
7. If the password is entered correctly, you can select
between altering the cabinet's configuration, or
calibration. Highlight the
press [OK/MUTE]
button until the
to enter the menu screen.
button until the
[OK/MUTE]
Warning Screen alerting you that you are
to input the password.
[TIMER] then [OK/MUTE].
Configuration
to start the configuration procedure.
[MENU] button.
Tools option is
Password option is
to select the
option, then
183