Skoda Octavia II 2004 Workshop Manual page 179

– Remove the front right wheelhouse liner ⇒ Body Work; Rep.
gr. 66 .
– Unscrew nuts -arrows B-.
– Bore out rivet head or pull-off screw -arrow A-.
– Disconnect plug.
– Remove horn from holder.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
Note
♦ Any damage to the paintwork during drilling must be repaired
by a specialist.
Replace drilled pull-off screws/riveted nuts with a new part ⇒
♦
Electronic Catalogue of Original Parts .
5.3 Removing and installing interior moni‐
toring sensor - G273- and vehicle incli‐
nation sender - G384-
Removing
The sensors are located in the cover of the moulded headliner.
– Switch off the ignition and all electrical consumers! The vehicle
must not be locked via the radio control receiver of the central
locking.
– Remove the cover -2- using the disassembly wedge - 3409- .
– Release locking tabs -arrows-.
– Remove the sensors -1- from the cover -2-.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
– When replacing the part with number "1Z0 951 171 A" with the
part with number "5J0 951 172" use the ⇒ Vehicle diagnostic
tester to perform the parameterisation of the functions of the
onboard control unit - J519- .
5.4 Removing and installing interior moni‐
toring deactivation switch - E267- and
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Octavia II 2004 ➤ , Octavia II 2010 ➤
Electrical system - Edition 12.2013
5. Anti-theft warning system
171