Removing And Installing Ignition Key Anti-Removal Lock Solenoid N376 - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤
Electrical system - Edition 12.2013
– Release ignition starter switch by inserting two small screw‐
drivers (e.g. watch-and-clock screwdriver) in the openings
-arrows- and by levering off the catch pegs.
– Pull ignition starter switch -1- out of the steering lock.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
Note
When installing the ignition/starter switch and the steering lock
must be in the same position, e.g. "Ignition ON".
– Insert ignition starter switch into the steering lock until there is
an audible click.
– Follow the work procedure when connecting the battery
⇒ page 2 .
8.5 Removing and installing ignition key an‐
ti-removal lock solenoid - N376-
Only on vehicles equipped with automatic gearbox.
Removing
Note
The steering wheel must not be removed. For installing the fixing
screws of the bottom trim panel for steering column, turn the
steering wheel to the left by 90° and subsequently turn it to the
right.
– First of all remove the top and then the bottom steering column
trim panel ⇒ Body Work; Rep. gr. 70 .
– Unlock catch -2- and pull out ignition key anti-removal lock
magnet -1- out of the clamp in direction of the arrow.
– To do so unplug the connector simultaneously.
Installing
The installation occurs in reverse order.
148
Rep. gr.94 - Lights, bulbs, switches - exterior
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�