Removing And Installing Steering Lock - Vehicles Up To Cw 21/10; Removing And Installing Steering Lock - Vehicles As Of Cw 22/10 - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤
Electrical system - Edition 12.2013
– Use the steel cable -2- to unlock the securing lever -3- of the
lock cylinder -arrow- and to pull the lock cylinder out of the
steering lock. For this step carefully slacken the cable to the
reader coil of the vehicle immobiliser.
– Separate plug connection for immobiliser -1-.
Note
The reader coil for the vehicle immobiliser is fixed to the lock cyl‐
inder and cannot be replaced separately.
Installing
– Place the ignition key in the lock cylinder and turn to position
"Ignition on".
– Fit the connector together on the reading coil for immobiliser.
– Insert the lock cylinder with the reader coil into the steering
lock housing until it clicks audibly into place.
Note
Pay attention to the correct position of the cable to the reader coil
of the vehicle immobiliser when inserting the lock cylinder.
– Fitting steering column trim ⇒ Body Work; Rep. gr. 70 .
– Follow the work procedure when connecting the battery
⇒ page 2 .
8.2 Removing and installing steering lock -
vehicles up to CW 21/10
The work sequence for removing and installing the steering lock
is the same as for the switch mounting
8.3 Removing and installing steering lock -
vehicles as of CW 22/10
Removing
– Remove steering wheel ⇒ Body Work; Rep. gr. 69 , bottom
and top steering column trim panel ⇒ Body Work; Rep. gr.
70 .
– Remove return ring with coil spring
146
Rep. gr.94 - Lights, bulbs, switches - exterior
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
⇒ page 137 .
⇒ page 142 .