Skoda Octavia II 2004 Workshop Manual page 44

Octavia II 2004 ➤ , Octavia II 2010 ➤
Electrical system - Edition 12.2013
– Compress plug catch -arrows-.
– Open catch clamp -arrow- and disconnect plug.
– Release plug of antenna socket -arrow- and disconnect.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
Note
When pushing the radio in, do not in any circumstances press on
the display or operating buttons. The radio may be damaged.
If the radio has been replaced:
– Adapt radio by entering the safety code
⇒ Vehicle diagnostic tester.
1.5.3 Radio "Swing", "Bolero"
Removing
– Check if there is no CD in the CD drive, if necessary take it out
⇒ Operating instruction of the radio .
Note
Radio Bolero has a 6 disc CD changer. After removing the last
CD, the CD drive is automatically switched off to protect it against
damage due to possible vibrations outside the vehicle cockpit.
– Switch off radio, the ignition and all electrical components.
– Vehicles with mobile phone holder - slacken mobile phone
holder ⇒ page 56 .
– Remove radio cover frame and heating/air conditioning sys‐
tem control using a disassembly wedge - 3409- .
36
Rep. gr.91 - Radio, telephone, navigation
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
⇒ page 30 and code