Parking Aid Sender Holder - Making Holes, Assignment, Fitting Location, Glueing Procedure; Parking Aid Sender Holder - Making Holes, Assignment, Fit- Ting Location, Glueing Procedure - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤
Electrical system - Edition 12.2013
9.6 Parking aid sender holder - making
holes, assignment, fitting location, glue‐
ing procedure
If the bumper is replaced, new sender holders must be affixed to
the new bumper.
Make holes in the new bumper see ⇒ Body Work; Rep. gr. 63 .
⇒ "9.6.1 Assignment of the sender holder", page 154
⇒ "9.6.2 Fitting position of the sender holders", page 154
⇒ "9.6.3 Gluing procedure of the sender holders", page 155
9.6.1 Assignment of the sender holder
The sender holders are different in shape and must be assigned
to the relevant fitting location. The inner and outer sender holders
are not identical. Assignment of the sender holders according to
construction year ⇒ Electronic Catalogue of Original Parts .
Note
Vehicles up to MY 08 - if the front sender holders are replaced,
♦
the holder with the marking "P-VNI-P" is glued on the left inner
side and with the marking "P-VNI-L" on the right inner side of
the bumper on Octavia Scout and RS vehicles. On other ve‐
hicles the holder with the marking "P-VNI-P" is glued on the
right inner side and with the marking "P-VNI-L" on the left inner
side of the bumper.
Vehicles as of MY 09 - both inner sender holders are identical,
♦
there is no difference between the left and the right.
9.6.2 Fitting position of the sender holders
The fitting position is determined by the peg on the holder -2- and
the contour of the holder on the bumper -1-.
154
Rep. gr.94 - Lights, bulbs, switches - exterior
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�