Skoda Octavia II 2004 Workshop Manual page 195

Vehicles up to MY 08
– Release catch pegs -arrows- and remove the control unit -1-
from the bracket -2- downwards.
Note
All plug connections are separated for purposes of clear presen‐
tation.
– Unlock the central locking system and then disconnect all the
plugs.
Vehicles as of MY 09
– Unclip the relay carrier under the vehicle voltage control unit
and unhook towards the bottom
– To disconnect the plugs,, successively press together the
catches on the plug connections -1- and disconnect the con‐
nectors from the control unit by swivelling out the bracket
-arrow-.
– Unhook the pulled-out connector -2- towards the bottom.
– Press together the catches -arrows A-, slightly swivel out the
control unit -arrow B- and push out of the bearing in the bracket
-arrow C-.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
Note
♦ If the vehicle voltage control unit - J519- is replaced, the new
control unit must be coded
After the replacement (depending on equipment) the functions
♦
of the control unit such as "remote control for central locking",
"anti-theft warning system", etc. must be adapted see
⇒ page 188 .
2.1.2 Coding the vehicle voltage control unit -
J519-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
Note
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Vehicles as of MY 2009 (Facelift) - for carrying out the coding, the
⇒ Vehicle diagnostic tester on-line (network connection) must be
connected.
– Connect the ⇒ Vehicle diagnostic tester.
⇒ page 179 .
⇒ page 187 .
Octavia II 2004 ➤ , Octavia II 2010 ➤
Electrical system - Edition 12.2013
187
2. Control units