Skoda Octavia II 2004 Workshop Manual page 146

Octavia II 2004 ➤ , Octavia II 2010 ➤
Electrical system - Edition 12.2013
WARNING
When boring out the screws splinters can penetrate into the
surrounding components and can cause damage and/or func‐
tional problems. Thus it is purposeful to remove these compo‐
nents before boring out the screws.
Removing
Remove the following components consecutively as follows:
– Steering wheel ⇒ Body Work; Rep. gr. 69 .
– Top and bottom steering column trim panel ⇒ Body Work;
Rep. gr. 70 .
– Steering column electronics control unit - J527-
– Return ring with coil spring - F350-
– Steering angle sender - G85-
– Left and right lever key
– Disconnect plug connection from the reader coil -arrow-.
Bore out fixing screws -1- for steering lock with lock cylinder and
ignition lock -3-.
– Slide switch mounting -2- with steering lock out of the steering
column.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
– Release the retaining lugs -arrows- and remove the steering
lock housing -2- from the mounting -1-.
Installing
– Insert steering lock with lock cylinder and ignition lock -3- into
the switch mounting -2-.
– Fit switch mounting with steering lock as far as possible onto
the steering column.
– Insert plug connection -arrow- into the reader coil at the lock
cylinder.
– Screw on steering lock with new pull-off screws -1- and tighten
until the screw heads are torn off.
– Install the other components in reverse order.
138
Rep. gr.94 - Lights, bulbs, switches - exterior
⇒ page 135
⇒ page 136 (if present).
⇒ page 136 .
⇒ page 134 .
.