Removing And Installing The Relay Carrier Under The Vehicle Voltage Control Unit J519 - Vehicles As Of My 09 - Skoda Octavia II 2004 Workshop Manual

– Release both fixing screws (2,5 Nm) -arrows- and take out the
fuse holder -1- towards the inside.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
– Follow the work procedure when connecting the battery
⇒ page 2 .
1.2 Removing and installing the relay carrier
under the vehicle voltage control unit -
J519- - vehicles as of MY 09
Note
The assignment of the relay carrier depends upon the vehicle
♦
equipment.
♦ Exact assignment of the relay carrier ⇒ Current flow diagrams,
Electrical fault finding and Fitting locations.
Removing
– Disconnect battery earth strap
– Remove lower part of the dash panel insert on the driver's side
⇒ Body; Rep. gr. 70 Work.
– Press together the catch pegs -arrows A- and push the relay
carrier -1- with relays out of the brackets at the vehicle voltage
control unit -2-.
– Take the relay out of the relay carrier.
⇒ page 2 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Octavia II 2004 ➤ , Octavia II 2010 ➤
Electrical system - Edition 12.2013
1. Fuse holder and relay carrier
179