Skoda Octavia II 2004 Workshop Manual page 83

– Use a suitable drill to drill open the four rivets -arrows- and take
out the faulty speaker.
Note
It is important to remove all the drill swarf from the door since
♦
it can otherwise lead to corrosion.
Any damage to the paintwork which is caused by drilling out
♦
the rivets must be repaired immediately by a specialist.
Installing
– Attach the new speaker with matching blind rivets.
– Further installation occurs in reverse order.
7.1.3 Removing and installing the front treble
speaker
The front treble speakers in the front doors are firmly connected
with the inner door control.
Removing
– Switch off radio/navigation.
– Remove the front door panelings ⇒ Body Work; Rep. gr. 70 .
– Disconnect socket connector to the loudspeaker.
– Removing the inner door control ⇒ Body Work; Rep. gr. 57 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
Installing
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
The installation occurs in reverse order.
7.1.4 Removing and installing the rear treble
speaker
The front treble speakers in the rear doors are firmly connected
with the inner door control.
Removing
– Switch off radio/navigation.
– Remove the rear door panellings ⇒ Body Work; Rep. gr. 70 .
– Disconnect socket connector to the loudspeaker.
– Removing the inner door control ⇒ Body Work; Rep. gr. 58 .
Installing
The installation occurs in reverse order.
7.1.5 Removing and installing the front mid‐
range speaker
Only on vehicles with the equipment "Soundsystem"
Removing
– Switch off radio/navigation.
– Remove the front door panelings ⇒ Body Work; Rep. gr. 70 .
– Disconnect socket connector at the loudspeaker.
Octavia II 2004 ➤ , Octavia II 2010 ➤
Electrical system - Edition 12.2013
7. Loudspeaker system
75