Skoda Octavia II 2004 Workshop Manual page 196

Octavia II 2004 ➤ , Octavia II 2010 ➤
Electrical system - Edition 12.2013
– Select operating mode "Targeted fault-finding".
– Skip - Selected Functions/Components and then:
♦ Body
♦ Electrical system
♦ 01 – Self-diagnosable systems
♦ Onboard supply control unit
♦ Operation
♦ Coding, change
Note
If the daylight driving light is activated (vehicles as of MY
♦
2009), in addition the function of the daylight driving light (de‐
pending on equipment) must be coded and the coding of other
functions must be carried out see ⇒ Vehicle diagnostic tester
Once the control unit has been coded, perform an adaptation
♦
⇒ page 188 .
2.1.3 Adapting the functions of the vehicle
voltage control unit - J519-
On the vehicle voltage control unit - J519- the following functions
can be adapted:
Note
The adaptability of the following functions depends on the equip‐
ment.
All vehicles:
♦ Adapt Coming Home Time
♦ Adapt Leaving Home Time
♦ Adapt visual acknowledgement when locking and unlocking
♦ Adapt acoustic acknowledgement when locking and unlocking
♦ Adapt sensitivity of interior monitoring
♦ Adapt sensitivity of vehicle inclination sender
♦ Adaptation of flash cycles for Convenience flashing
♦ Adapt key with radio remote control
♦ Adjust headlamp washer interval
Vehicles as of MY 2009 (Facelift) additionally:
Note
Vehicles up to MY 2008 - the following functions can be adapted
via the Convenience system central control unit - J393- . This
control unit is no longer fitted as of MY 2009, the vehicle voltage
control unit - J519- takes over its functions.
♦ adapt automatic locking at 15 km/h
♦ adapt automatic unlocking when the ignition key is removed
188
Rep. gr.97 - Wiring
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�