Skoda Octavia II 2004 Workshop Manual page 98

Octavia II 2004 ➤ , Octavia II 2010 ➤
Electrical system - Edition 12.2013
– Carefully pull out the spray nozzle in -the direction of arrow-.
– Loosen the nut -arrow-.
– To loosen the wiper arm from the cone, use a small commer‐
cially available two-arm extractor.
– Unscrew nut and remove wiper arm with wiper blade.
Installing
– Switch wiper motor on and off again and run until it is in park
position.
– Fit the wiper arm with wiper blade and set the final setting:
Octavia:
The distance -a- between the wiper blade and the lower edge of
the rear window is 36 mm
Octavia Combi:
The distance -a- between the wiper blade and the lower edge of
the rear window is 22 mm
– Slightly tighten fixing nut.
– Operate the flick wipe and check again or correct the setting
of the wiper arm.
– Tighten fixing nut (12 Nm).
2.2.2 Removing and installing rear window
wiper motor, Octavia
Removing
– Switch off the ignition and all electrical consumers!
– Remove wiper arm with wiper blade
90
Rep. gr.92 - Windscreen wash/wipe system
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
⇒ page 89 .