Skoda Octavia II 2004 Workshop Manual page 46

Octavia II 2004 ➤ , Octavia II 2010 ➤
Electrical system - Edition 12.2013
– Release plug of antenna socket -arrows- and disconnect.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
Note
When pushing the radio in, do not in any circumstances press on
the display or operating buttons. The radio may be damaged.
If the radio has been replaced:
– Adapt radio by entering the safety code
⇒ Vehicle diagnostic tester.
1.5.4 Switching off CD drive of radio AUDI‐
ENCE
It is carried out before removing the radio from the vehicle.
Work procedure
– Withdraw ignition key and switch on the radio with the rotary
knob.
– Press the "EJECT" button to make sure the changer is empty
(all positions NO CD) - see ⇒ Operating instructions of radio .
– Press both buttons marked with simple arrow -Fig.- and hold
for approx. 2 seconds. After the display "SYSTEM
DEBUG" (see the last fig.), release the buttons.
– Select the field "HARDWARE" with the pre-selection button
-fig.-. By actuating this button switch over to the next display.
38
Rep. gr.91 - Radio, telephone, navigation
⇒ page 30 and code
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�