Skoda Octavia II 2004 Workshop Manual page 99

– Remove the bottom tailgate trim panel ⇒ Body Work; Rep. gr.
70 .
– Unplug connector -1- at wiper motor.
– Detach hose -2- to spray nozzle.
– Unscrew nuts/screws (7 Nm) -arrows- and remove wiper mo‐
tor.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
– Take fitting position of implementation into account. Recess in
the rear window implementation -arrow- points downwards,
see Fig.
2.2.3 Removing and installing rear window
wiper motor Octavia Combi
Removing
– Switch off the ignition and all electrical consumers!
– Remove wiper arm with wiper blade
– Remove the bottom tailgate trim panel ⇒ Body Work; Rep. gr.
70 .
– Unplug connector -1- at wiper motor.
– Unscrew nuts (7 Nm) -arrows- and remove wiper motor.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Octavia II 2004 ➤ , Octavia II 2010 ➤
⇒ page 89 .
Electrical system - Edition 12.2013
2. Windscreen Wiper and Washer System
91