Skoda Octavia II 2004 Workshop Manual page 95

– Insert windscreen wiper arms with wiper blades and align wip‐
er blades to the markings in the windscreen -1-.
– Slightly tighten fixing nuts.
– Operate the flick wipe and check again or correct the setting
of the wiper arms.
– Tighten securing nuts (17 Nm).
Note
The tolerance between wiper blade and marking -1- is ± 3 mm.
2.1.4 Removing and installing wiper motor
with linkage
Removing
– Switch off the ignition and all electrical consumers!
– Remove wiper arms with wiper blades
– Remove the plenum chamber cover ⇒ Body Work; Rep. gr.
66 .
– Unplug connector -1- at wiper motor.
– Release screws -arrows- (10 Nm).
– Place wiring loom down to the side.
– Removing wiper motor with linkage -2-. Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
– When installing the rig pin -2- correctly insert into rubber bear‐
ing -1- in the body.
2.1.5 Removing and installing wiper motor
from linkage
Removing
Special tools and workshop equipment required
♦ Disassembly tool for door panel - MP8-602/1-
Octavia II 2004 ➤ , Octavia II 2010 ➤
⇒ page 85 .
Electrical system - Edition 12.2013
2. Windscreen Wiper and Washer System
87