Skoda Octavia II 2004 Workshop Manual page 135

– Press the catch -arrow- from the inside, swivel out the fog light
and remove it.
– Disconnect plug.
Installing
– Mount plug.
– Insert the headlight in the assembly opening and press it in
until it clicks into place -arrow-.
– Install shock absorber cover.
– Perform a functional check or adjust ⇒ Maintenance ; Booklet
Octavia II .
5.2.3 Removing and installing - Octavia RS
and Scout - vehicles up to CW 21.09
Removing
– Switch off the ignition and all electrical consumers!
– Remove front bumper ⇒ Body Work; Rep. gr. 63 .
– Disconnect plug.
– Screw out the screw -arrows- (1.5 Nm) and remove the fog
lights.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
– Perform a functional check or adjust ⇒ Maintenance ; Booklet
Octavia II .
5.2.4 Removing and installing - Octavia RS
and Scout - vehicles as of CW 22/09
Removing
– Switch off the ignition and all electrical consumers!
– Octavia RS - insert a finger in the opening of the cover for fog
light and unclip from the bumper.
– Octavia Scout - insert a wire hook from the repair kit in the
opening above the fog light -arrow- and remove the cover
-1-.
– Unscrew the screws -arrows- (1.5 Nm) and remove fog light
(Octavia RS) or daylight driving light/fog light (Octavia Scout
-1-).
Octavia II 2004 ➤ , Octavia II 2010 ➤
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
5. Fog lights, fog lights with the "Corner" function and daylight driving light
Electrical system - Edition 12.2013
127