Skoda Octavia II 2004 Workshop Manual page 142

Octavia II 2004 ➤ , Octavia II 2010 ➤
Electrical system - Edition 12.2013
1 - Left lever key
♦ Removing and installing
⇒ page 136
2 - Switch mounting on the
steering column
♦ Removing and installing
⇒ page 137
3 - Right lever key
♦ Removing and installing
⇒ page 136
4 - Fixing screw
5 - Steering column electronics
control unit - J527-
♦ Removing and installing
⇒ page 134
6 - Return ring with coil spring
- F350-
♦ Removing and installing
⇒ page 135
7 - Steering angle sender -
G85-
♦ Removing and installing
⇒ page 136
♦ Right-hand drive as of CW
22/08 and left-hand drive
as of CW 22/09 - sender in‐
tegrated in the steering
gear
7.1.2 Removing and installing steering col‐
umn electronics control unit - J527-
Note
The new control unit must be coded after the installation see
⇒ Vehicle diagnostic tester.
Special tools and workshop equipment required
♦ Drill ∅ 2.5 mm
Removing
– Disconnect battery earth strap
– Remove steering wheel ⇒ Body Work; Rep. gr. 69 .
– Removing top and bottom steering column trim ⇒ Body Work;
Rep. gr. 70 .
134
Rep. gr.94 - Lights, bulbs, switches - exterior
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
⇒ page 2 .