Skoda Octavia II 2004 Workshop Manual page 72

Octavia II 2004 ➤ , Octavia II 2010 ➤
Electrical system - Edition 12.2013
– for audio
– for audio und telephone
2 - Three-spoke steering wheel
– for audio
– for audio und telephone
3 - Three-spoke steering wheel
– for audio, telephone and gearbox operation in the Tiptronic
mode (gearbox 02E - DSG)
5.2.2 Removing and installing switch units for
operating the audio and phone
The mounting sequence is identical for both switch units.
Removing
– Remove the airbag unit in the steering wheel ⇒ Body Work;
Rep. gr. 69 .
– Clear away wiring harness -arrows- and disconnect plug con‐
nection -1- from the switch unit.
– Swivel out the switch unit -2- -arrow- until the locking bolts
-1- become loose, push it slightly and pull it out.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
Note
Before the airbag is installed, it must be checked if all the wiring
♦
is properly pressed back into the guiding grooves in the steer‐
ing wheel foam. Wiring which protrudes can be damaged by
the backside parts of the airbag.
Follow the work procedure when connecting the battery
♦
⇒ page 2 .
– If the left switch unit has been replaced by an integrated control
unit, coding must be performed with ⇒ Vehicle diagnostic test‐
er.
5.2.3 Removing and installing switch units for
gearbox operation in Tiptronic mode
(gearbox 02E, 0AM – DSG)
The mounting sequence is identical for both switch units.
64
Rep. gr.91 - Radio, telephone, navigation
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�