Skoda Octavia II 2004 Workshop Manual page 200

Octavia II 2004 ➤ , Octavia II 2010 ➤
Electrical system - Edition 12.2013
2.3.2 Removing and installing
Note
If the data bus diagnostic interface Gateway - J533- is re‐
♦
placed, it must be connected before the removal ⇒ Vehicle
diagnostic tester and the function "replace data bus diagnostic
interface" must be selected in the targeted fault finding for
reading the codes stored in the control unit.
If the original data bus diagnostic interface Gateway - J533- is
♦
not available or does not communicate with the diagnostic unit,
then proceed according to the information in the ⇒ Vehicle di‐
agnostic tester.
The coding can also be performed on-line (network connec‐
♦
tion).
Remove - left-hand drive
The data bus diagnostic interface Gateway - J533- is located on
the strut above the brake pedal.
– Switch off the ignition and all electrical consumers!
– Remove lower part of the dash panel insert on the driver's side
⇒ Body; Rep. gr. 70 Work.
– Unlock -arrows- control unit -1- and remove from control panel
holder.
– Disconnect plug connection -2-.
Remove - right-hand drive
The data bus diagnostic interface Gateway - J533- is located
above the onboard supply control unit - J519- at the rear.
– Removing the dash panel ⇒ Body Work; Rep. gr. 70 .
– Disconnect plug connection -3-.
– Press off the catch peg -arrow A- and push out -arrow B- the
diagnostic interface -1- from the bracket -2-.
Installing
The installation occurs in reverse order.
192
Rep. gr.97 - Wiring
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�