Skoda Octavia II 2004 Workshop Manual page 193

– Press the catch pegs apart from one another at the E-box
holder -arrows B- and push the flat contact housing -1- out of
the E-box holder to the side -arrow A-.
– Unlock the flat contact housing -2- (if present) -arrows C- and
push it out of the E box holder -arrow D-.
– Screw out fixing nuts -arrows- (9 Nm) and take out the E-box
holder -1-.
– Vehicles with diesel engine - press additional relay carrier
-1- out of the E box holder -2-.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Note
On vehicles where there is a label on the cover of the E box with
a note indicating the required change of the multi-pin fuse (moun‐
ted as of 11.08), this fuse must be replaced when loosening the
nut -1-.
– Make sure the upper trim panel correctly locks into position.
– Follow the work procedure when connecting the battery
⇒ page 2 .
Octavia II 2004 ➤ , Octavia II 2010 ➤
Electrical system - Edition 12.2013
1. Fuse holder and relay carrier
185