ALGE-Timing TDC8001 Manual page 69

RS232c Interface
Output format
Transfer rate:
Transfer protocol:
xNNNNiCCxxHH:MM:SS.zhtqx##(CR) ......... Parallel slalom, intermediate time, finish time
xNNNNiRTxxHH:MM:SS.zhtqx##(CR) ......... Parallel slalom, run time
xNNNNiDTRxHH:MM:SS.zhtxx##(CR) ......... Parallel slalom, run difference time
xNNNNiTTxxHH:MM:SS.zhtqx##(CR) ......... Parallel slalom, total time
xNNNNiDTTxHH:MM:SS.zhtxx##(CR) ......... Parallel slalom, total difference time
pNNNNiCCxxHH:MM:SS.zhtqx##(CR) ......... Parallel slalom, finish time calculated from penalty time
pNNNNiRTxxHH:MM:SS.zhtqx##(CR) ......... Parallel slalom, run time calculated from penalty time
pNNNNiTTxxHH:MM:SS.zhtqx##(CR) ......... Parallel slalom, total time calculated from penalty time
x .............................. blank
NNNN ..................... start number (four-digit)
i ............................... r (= red/right), b (= blue) or L (= left) course parallel slalom
CC ........................... timing channel
RT ........................... run time
DTR ........................ Difference Time Run
DTT ......................... Difference Time Total
HH:MM:SS.zht ........ time in hours, minutes, seconds and 1/1000 seconds
HH:MM:SS.zhtq ...... time in hours, minutes, seconds and 1/10,000 seconds
## ............................ consecutive numbers at each heat
(CR) ........................ Carriage Return
The following figures can be in 1
? .............................. time without valid start number
c .............................. times cleared (with CLEAR key)
p .............................. time calculated from penalty time at parallel slalom (penalty time)
RS485 interface: no function at current TdC 8001
Manual
TdC 8001
1 Startbit, 8 Databit, no Paritybit, 1 Stopbit
9,600 baud default setting (adjustable: 2400, 4800, 9600)
ASCII
position:
st
-69-