Turning On And Continuation In The Same Heat; Second (Next) Heat - ALGE-Timing TDC8001 Manual

3.1.2

Turning on and continuation in the same heat

− The activation operation is the same as with the 1. Heat.
As the race is continued in the same heat, the memory must not be cleared.
−
− Select correct race.
The info display (7) shows as follows:
−
Select heat:
Continue: ENTER
− Press <F1> and <ENTER> to select and confirm the same heat.
− Re-synchronize timing device or use internal clock as time of day.
The timing device is ready.
−
3.1.3

Second (next) heat

Up to 256 heats can be carried out. In every heat the total time from the previous heats as well as the
current heat are saved. There are two possibilities to switch to the next heat:
Turn off TdC 8001 and on again
−
Change heat in the main menu (see chapter 0).
−
For every competitor the following times are printed:
−
0012 SZ
ZZ
LZ
MZ
TZ
In the main menu (menu 8) you can set if the time starts at zero or at the total time of previous heats.
After crossing the finish line display (7) first shows run time, then total time or first total time, then run
time and again total time. Set the display time for the run time and total time in main menu (menu 4/5).
Change heat in main menu
Advantage: no re-synchronization necessary; all pre-set value are stored.
Disadvantage: In case of long breaks in between heats the device is always activated. I. e. the longer
the break the more time deviation happens. Without connected mains supply, energy
from the batteries is spent.
− Press <ALT> and <MENU> at the same time.
Select "Change heat" in menu 24 with the cursor.
−
Menu 24: CHANGE HEAT
Select: YES/NO or Menu number: 24
− Press <YES>
Select heat:
Continue: ENTER
Select next heat with <F2> + <ENTER>. The number in parentheses shows the heat number.
−
Start order:
BIBO WITHOUT GROUPS
Continue: ENTER
Manual
TdC 8001
SAME (1) <
NEXT (2)
10:07:04.640
10:08:35.150
1:30.50
1:32.38
3:02.88
SAME (1) <
NEXT (2)
START NUMBER <
BIBO WITH GROUPS
F1 The number is for 1. Heat
F2 The number is for 2. Heat
Start time (time of day)
Finish time (time of day)
Run time
Memory time
Total time
F1 continue in same heat
F2 next heat
F1
F2
F3
-21-