− Start number:
− Bibo without groups:
− Bibo with groups:
−
TdC 8001 is ready for next heat.
Change heat by turning off the TdC 8001:
The batteries are preserved.
Advantage:
Disadvantage: The TdC 8001 and other timing devices (start clock, auxiliary timing, etc.) must be re-
synchronized.
In case a heat has already been carried out, you follow the same procedure for all following heats.
If you change from one heat to the next, turn the TdC 8001 off and on with switch (g). You must not clear
the memory of the race in which the previous heat is saved.
−
Turn on as with 1. heat
Attention: do not clear the race for which the 2. heat is carried out
−
−
Select correct race
The info display (7) shows the following:
−
Select heat:
Continue: ENTER
−
Select next heat with <F2> and <ENTER>. The number in parentheses shows which heat.
Start order:
BIBO WITHOUT GROUPS
Continue: ENTER
− Start number:
− Bibo without groups:
− Bibo with groups:
− Synchronization of the TdC 8001:
Time: 10:15:23
Date: 11-02-28
Continue: ENTER
The synchronization can be executed in two different ways. Select with <F1> or <F2> (see
−
chapter 2.11)
The TdC 8001 is ready for the next heat.
−
Manual
TdC 8001
The start order can be set with menu 53 - as for the 1. heat (count
up, manual, count down)
The start order for all competitors is according to Bibo. Enter number
of competitors to be inverted and confirm with <ENTER>.
The start order for every group is according to Bibo. Enter number
of competitors to be inverted for every group, confirm: <ENTER>.
SAME (1) <
NEXT (2)
START NUMBER <
BIBO WITH GROUPS
Set the start order – as for the 1. heat – with menu 53 (count up,
manual, count down)
Start order for all competitors according to Bibo. Set the number
of competitors to be inverted and confirm with <ENTER>.
Start order for each group acc. to Bibo. Set number of competi-
tors to be inverted for each group, confirm with <ENTER>.
OK
WRONG
F1 continue in same heat
F2 next heat
F1
F2
F3
<
F1
time and date are correct
F2
time or date is wrong
-22-
Need help?
Do you have a question about the TDC8001 and is the answer not in the manual?
Questions and answers