Start Mode; Single Start; Start Procedure For 2 Nd Heat - ALGE-Timing TDC8001 Manual

3.3

Start Mode

There are three different start modes:

− Single start:

− Group start:
− Mass start:
You can set the mode of the automatic stepping with menu 53. The set value is also indicated on the
start display by a beam.
Beam functions:
− At the top: after the start the start number jumps up to the next start number that has not yet
started
− In the middle: manual mode, every start number has to be entered with the start keypad (12)
− At the bottom: after the start the start number jumps down to the next start number that has not
yet started
ATTENTION: Set the start number in the start display on 0 to deactivate the automatic stepping.
3.3.1 Single Start
Every competitor has a separate start time, i.e. one competitor starts after the other. The output mode
of the info display (7) can be set for single starts (see menu 7: info display).
3.3.1.1
Start Procedure for 1. Heat:
The start procedure can be atomized if the start order corresponds to the start numbers.
Start numbers count automatically up after every start:
Set menu 53 on upwards (setting is shown on display (2))
−
− Display (1) shows 1 as start number
After every further start, the start number is increased (automatically to the next number that
−
has not yet started)
A manual correction is always possible. Press <ENTER> to increase the start number.
−
Display (1) shows a "b" next to the start number if this one is started.
−
Start numbers count automatically down after every start:
− Set menu 53 on downwards (setting is shown on display (2))
Display (1) shows 1 as start number
−
Set start number that starts first (e. g. 48) and confirm with <ENTER>
−
− After the start, the start number is decreased (automatically to the next number that has not yet
started)
− A manual correction is always possible. Press <ENTER> to decrease the start number.
Display (1) shows a "b" next to the start number if this one is started.
−
Manual start number input:
Set menu 53 on middle (setting is shown on display (2))
−
− Enter start number with keypad (12) that starts first (e. g. 12) and confirm with <ENTER>
After the start, a "b" shows next to the start number indicating that it has started
−
Enter next start number and confirm with <ENTER>.
−
− After the start, a "b" shows next to the start number indicating that it has started
Manual
TdC 8001
every competitor has a separate start time
every group has a separate start time (within the group one start time)
all competitors start at the same time (same start time)
-25-