Fujitsu MB86617A Specification Sheet page 115

Ieee1394 serial bus controller for dtv
Table of Contents

Advertisement

LSI S pecification
Interrupt
INT7
Isochronous cycle too long
INT8
Bus occupancy violation
INT9
Asynchronous packet received
INT10
CPIF output header is no 47h (Transmit)
INT11
Data length short error
INT12
Data length long error
INT13
Packet format error
INT14
Header CRC error
INT15
Data CRC error
INT16
Asynchronous receive FIFO full
INT17
Asynchronous packet send
INT18
Input CGMS or TSCH changed
INT19
Acknowledge missing
INT20
Acknowledge send
INT21
Receive EMI or ODD/EVEN changed
INT22
First packet received
Rev.1.0
Interrupt Item
Isochronous cycle exceeded specified time.
>Informs only if this node is Cycle master.
Node occupied longer time than MAX_DATA_TIME.
>Need to issue "Bus reset".
Received Asynchronous packet addressed to self-node normally, and
stored data at ASYNC receive specific buffer.
Header byte of source packet output from CPIF at transmitting
MPSG2 -TS is not '47h'.
>Valid only when transmitting MPSG2-TS.
Receive packet data length is shorter than data-length of packet header.
Receive packet data length is longer than data-length of packet header.
>Store only data indicated by data-length value to buffer.
Detected format error in packet received.
Occurred convention failure of packet format like Reserved range is not
'0'.
>Delete packet received.
Detected CRC error in the header of packet received.
>Delete packet received.
Detected CRC error in the data range of packet received.
>Do not delete packet received.
ASYNC receive specific buffer is full.
>Delete following packet received.
Completed sending Asynchronous packet by issueing instruction.
CGMS or TSCH information input from TSP IC I/F was not consistent
with the souce packet input just before.
Not returned Acknowledge packet in correspondance with Asynchronous
packet of non-broadcast sent from self-node within specified limit.
Completed sending Acknowledge packet.
Changede EMI data or ODD/EVEN value of received Isochronous
packet.
Received the first packet after setting receive ISO channel.
Description
110
MB86617A
Fujitsu VLSI

Advertisement

Table of Contents
loading

Table of Contents