Table of Contents
Advertisement
1 SAFETY
1.3
User responsibility
Users of ESAB equipment have the ultimate responsibility for ensuring that anyone who works on or
near the equipment observes all the relevant safety precautions. Safety precautions must meet the
requirements that apply to this type of equipment. The following recommendations should be
observed, in addition to the standard regulations that apply to the workplace.
All work must be carried out by trained personnel well-acquainted with the operation of the equipment.
Incorrect operation of the equipment may lead to hazardous situations, which could result in injury to
the operator and damage to the equipment.
1. Anyone who uses the equipment must be familiar with:
•
its operation
•
the location of emergency stops
•
its function
•
the relevant safety precautions
•
welding and cutting or other applicable operation of the equipment
2. The operator must ensure that:
•
no unauthorized person is within the working area of the equipment when it is started up
•
no-one is unprotected when the arc is struck or work is started with the equipment
3. The workplace must:
•
be suitable for the purpose
•
be free from drafts
4. Personal safety equipment:
•
Always wear recommended personal safety equipment, such as safety glasses, flame-proof
clothing, safety gloves
•
Do not wear loose-fitting items, such as scarves, bracelets, rings, etc., which could become
trapped or cause burns
5. General precautions:
•
Make sure the return cable is connected securely
•
Work on high voltage equipment may only be carried out by a qualified electrician
•
Appropriate fire extinguishing equipment must be clearly marked and close at hand
•
Lubrication and maintenance must not be carried out on the equipment during operation
WARNING!
Wire feeders are intended to be used in GMAW (MIG/MAG) mode only.
If used in any other welding mode, such as SMAW (MMA), the welding cable between wire
feeder and power source must be disconnected, or else the wire feeder becomes live or
energized.
If equipped with ESAB cooler
Use ESAB approved coolant only. Non-approved coolant might damage the equipment and jeopardize
product safety. In case of such damage, all warranty undertakings from ESAB cease to apply.
Recommended ESAB coolant ordering number: 0465 720 002.
For ordering information, see the "ACCESSORIES" chapter in the instruction manual.
WARNING!
Arc welding and cutting may cause injury to yourself and others. Take precautions when
welding and cutting.
0447 954 001
- 7 -
© ESAB AB 2023
Advertisement
Table of Contents
