Table of Contents
Advertisement
6 CONTROL PANEL
6.3.3
MMA welding
MMA welding may also be referred to as welding with coated electrodes. Striking the
arc melts the electrode, and its coating forms protective slag.
For MMA welding the power source shall be supplemented with:
•
welding cable with electrode holder
•
return cable with clamp
6.3.4
MMA cel 6010 welding
Optimized arc characteristic for cellulosic electrodes such as 6010 and similar.
6.3.5
MIG/MAG
An arc melts a continuously supplied wire. The weld pool is protected by shielding gas.
For MIG/MAG welding, the power source shall be supplemented with:
•
wire feed unit
•
welding torch
•
connection cable between power source and wire feed unit
•
gas cylinder
•
return cable with clamp
6.4
Measured or set values
Measured or set voltage
Measured or set value in the display for arc voltage V is an average arithmetic value.
Measured or set amperage
Measured or set value in the display for welding current A is an average arithmetic
value.
0463 772 101
- 23 -
© ESAB AB 2024
Advertisement
Table of Contents
