Procedures To Install And Wire Options On A Drive; Procedure A - YASKAWA SI-N3 Technical Manual

WARNING Electrical Shock Hazard. Do not remove covers or touch circuit boards while the drive is energized. If you
touch the internal components of an energized drive, it can cause serious injury or death.
WARNING
Electrical Shock Hazard. Do not use damaged wires, put too much force on the wiring, or cause damage to
the wire insulation. Damaged wires can cause serious injury or death.
WARNING Fire Hazard. Tighten all terminal screws to the correct tightening torque. Connections that are too loose or too
tight can cause incorrect operation and damage to the drive. Incorrect connections can also cause death or serious injury from
fire.
NOTICE Damage to Equipment. When you touch the option, make sure that you observe correct electrostatic
discharge (ESD) procedures. If you do not follow procedures, it can cause ESD damage to the drive circuitry.
NOTICE
Damage to Equipment. Do not de-energize the drive while the drive is outputting voltage. Incorrect equipment
sequencing can cause damage to the drive.
NOTICE Do not operate a drive or connected equipment that has damaged or missing parts. You can cause damage to
the drive and connected equipment.
NOTICE
Use Yaskawa connection cables or recommended cables only. Incorrect cables can cause the drive or option
to function incorrectly.
NOTICE
Damage to Equipment. Correctly connect the connectors. Incorrect connections can cause malfunction or
damage to the equipment.
NOTICE
Damage to Equipment. Make sure that all connections are correct after you install the drive and connecting
peripheral devices. Incorrect connections can cause damage to the option.
◆

Procedures to Install and Wire Options on a Drive

Procedures to install and wire the option are different for different drive models.
Refer to the following table to check the procedures to install and wire the option on a drive.
Drive
A1000
E1000
H1000
L1000A
U1000
Z1000U
Z1000
GA500
GA700
GA800
FP605
*1 To install the option on GA500 drives, use the option mounting kit (JOHB-GA50) and manual.
*2 Before you install the option on a GA500 drive, make sure that the option software version is PRG: 1115 or later.
■

Procedure A

This section shows the procedure to install and wire the option on a 1000-series drive.
Prepare the Drive for the Option
Before you install the option on a YASKAWA AC Drive L1000A, U1000 or Z1000U, make sure that the option
software version is PRG: 1112 or later.
Correctly wire the drive as specified by the manual packaged with the drive. Make sure that the drive functions
correctly. Refer to the drive manuals for more information.
YASKAWA SIEP C730600 84F DeviceNet Technical Manual
Table 5.1 Procedures to Install and Wire Options on a Drive
Procedures to Install and Wire Options on a Drive
Procedure A
Procedure A
Procedure A
Procedure A
Procedure A
Procedure A
Procedure B
*1 *2
Procedure C
Procedure C
Procedure D
5 Installation Procedure
Reference Page
13
13
13
13
13
13
16
-
19
19
22
13