Settings For Dip Switch S1; Procedures To Install And Wire The Option; Procedure A - YASKAWA BACnet/IP JOHB-SMP3 Technical Manual

NOTICE Damage to Equipment. Make sure that all connections are correct after you install the drive and connecting
peripheral devices. Incorrect connections can cause damage to the option.
◆

Settings for DIP Switch S1

Use the DIP switch S1 on the option to select the communication protocol.
Use non-conductive tweezers or a tool with a tip width of approximately 0.5 mm (0.02 in) to set DIP switch S1.
Figure 5.1 shows the default settings for DIP switch S1.
When you use BACnet/IP, set DIP switch S1 as shown in
Note:
If you set the DIP switch for a different protocol, it will erase all user-entered data from the JOHB-SMP3, including the Device Object
Name.
◆

Procedures to Install and Wire the Option

Procedures to install and wire the option are different for different drive models.
Refer to Table 5.1 to check the procedures to install and wire the option on a drive.
Product Series
Z1000U
FP605
HV600
HV600 Bypass
■

Procedure A

This section shows the procedure to install and wire the option on a Z1000U drive.
Prepare the Drive for the Option
Correctly wire the drive as specified by the manual packaged with the drive. Make sure that the drive functions
correctly. Refer to the drive manuals for more information.
YASKAWA SIEP C730600 0MA BACnet/IP Technical Manual
Figure 5.1 Default Settings for DIP Switch S1
Figure 5.2 BACnet/IP Settings for DIP Switch S1
Table 5.1 Procedures to Install and Wire Options on a Drive
Procedures to Install and Wire Options on a Drive
Figure 5.2.
Procedure A
Procedure B
Procedure B
Procedure C
5 Installation Procedure
Reference
11
13
13
15
11