Procedure C - YASKAWA SI-N3 Technical Manual

A - Drive grounding terminal (FE)
B - Included screws
5.
Firmly connect the DeviceNet communication cable to the option terminal block (CN1).
Isolate communication cables from main circuit wiring and other electrical and power lines. Make sure that
you firmly connect the cable end. (Refer to
28 for more information.
NOTICE
discharge (ESD) procedures. If you do not follow procedures, it can cause ESD damage to the drive circuitry.
6.
Reattach the drive front cover (A) and the keypad (B).
Refer to the drive manuals for more information.
NOTICE
erroneous operation.
A - Drive front cover
7.
Set drive parameters in
■

Procedure C

This section shows the procedure to install and wire the option on a GA700 or GA800 drive.
Prepare the Drive for the Option
Before you install the option on a YASKAWA AC Drive GA700 or GA800, make sure that the option software
version is PRG: 1115 or later.
YASKAWA SIEP C730600 84F DeviceNet Technical Manual
Figure 5.11 Connect the Ground Wire
Damage to Equipment. When you touch the option, make sure that you observe correct electrostatic
Do not pinch cables between the front covers and the drive. Failure to comply could cause
Figure 5.12 Replace the Front Cover and Keypad
Related Drive Parameters on page 30
C - Ground wire
Figure 5.27). Refer to Communication Cable Wiring on page
B - Keypad
for correct option performance.
5 Installation Procedure
19