Procedure D - YASKAWA SI-N3 Technical Manual

5 Installation Procedure
A - Option
B - Included screws
5.
Firmly connect the DeviceNet communication cable to option terminal block (CN1).
Isolate communication cables from main circuit wiring and other electrical and power lines. Refer to
Communication Cable Wiring on page 28
NOTICE
discharge (ESD) procedures. If you do not follow procedures, it can cause ESD damage to the drive circuitry.
6.
Reattach the LED Status Ring board (E), front cover (C), and keypad (D).
Refer to the drive manuals for more information.
NOTICE
comply could cause erroneous operation.
Note:
• Replace the keypad connector, then install the keypad.
• Put the keypad connector tab into the holder when you install the keypad connector to the holder.
A - Keypad connector tab
B - Keypad connector
C - Drive front cover
Figure 5.18 Install the LED Status Ring board, Front Cover, and Keypad
7.
Set drive parameters in
■

Procedure D

This section shows the procedure to install and wire the option on an FP605 drive.
Prepare the Drive for the Option
Before you install the option on an FP605 drive, make sure that the option software version is PRG: 1115 or later.
22
Figure 5.17 Install the Option
Damage to Equipment. When you touch the option, make sure that you observe correct electrostatic
Do not pinch cables between the front cover or the LED Status Ring board and the drive. Failure to
Related Drive Parameters on page 30
C - Connector CN5-A
for more information.
D - Keypad
E - LED Status Ring board
for correct option performance.
YASKAWA SIEP C730600 84F DeviceNet Technical Manual