Option Installation - YASKAWA SI-N3 Technical Manual

◆

Option Installation

Verify the following installation conditions to make sure that other devices and machinery used with this option
and drive also comply with EMC guidelines:
1.
Use dedicated shield cable for the option and external device (encoder, I/O device, master), or run the
wiring through a metal conduit.
2.
Keep wiring as short as possible and ground the largest possible surface area of the shield to the metal
panel according to
Figure 14.2 Option Installation for CE Compliance: 1000-Series, GA700, GA800
YASKAWA SIEP C730600 84F DeviceNet Technical Manual
Figure 14.2 and Figure 14.3.
Figure 14.3 Option Installation for CE Compliance: GA500
14 European Standards
99