3-Wire Control1 (Vendor Specific Yaskawa Electric (Ye) Assy) - 103 (0X67) - YASKAWA SI-N3 Technical Manual

8 Output Assemblies (Drive Consumes)
Name
Multi-Function Input 7
Multi-Function Input 8
External Fault
Fault Reset
1000-Series, GA500: Multi-Function Digital
Output
GA700, GA800, FP605: Multi-Function Digital
Output 1
1000-Series, GA500: Multi-Function Photocoupler
1
GA700, GA800, FP605: Multi-Function Digital
Output 2
1000-Series, GA500: Multi-Function Photocoupler
2
GA700, GA800, FP605: Multi-Function Digital
Output 3
*2
Multi-Function Digital Output 4
Speed Reference
Acceleration Time 1
Deceleration Time 1
*1 Terminals are different for different drive models. Refer to
for more information.
*2 Multi-function digital output 4 is not available for 1000-Series, GA500, GA800, or FP605 drives.
◆

3-Wire Control1 (Vendor Specific Yaskawa Electric (YE) Assy) - 103 (0x67)

Note:
The drive is compatible with option software versions 1107 and later.
Output Instance Byte
0
103 1
2
40
Terminal S7 Function Input
0: Terminal S7 Function [H1-07] OFF
1: Terminal S7 Function [H1-07] ON
Terminal S8 Function Input
0: Terminal S8 Function [H1-08] OFF
1: Terminal S8 Function [H1-08] ON
External Fault EF0
0: -
1: External Fault [EF0]
Fault Reset
0: -
1: Fault Reset
1000-Series, GA700, GA800, FP605: Terminal M1/M2
0: M1/M2 OFF
1: M1/M2 ON
GA500: Terminal MA/MB
0: MA/MB OFF
1: MA/MB ON
This function is enabled only when H2-01 = F.
1000-Series, GA500: Terminal P1
0: P1 OFF
1: P1 ON
GA700, GA800, FP605: Terminal M3/M4
0: M3/M4 OFF
1: M3/M4 ON
This function is enabled only when H2-02 = F.
1000-Series, GA500: Terminal P2
0: P2 OFF
1: P2 ON
GA700, GA800: Terminal P1
0: P1 OFF
1: P1 ON
FP605
0: MD/MF OFF
1: MD/MF ON
This function is enabled only when H2-03 = F.
*1
Terminal P2
0: P2 OFF
1: P2 ON
This function is enabled only when H2-04 = F.
Speed Reference
Sets drive speed reference.
Units are determined by parameter o1-03 [Frequency Display Unit Selection].
Unit is not affected by Speed Scale SS.
C1-01 [Acceleration Time 1]
Units set in C1-10 [Accel/Decel Time Setting Units].
Unit is not affected by Time Scale TS.
C1-02 [Deceleration Time 1]
Units set in C1-10.
Unit is not affected by Time Scale TS.
Bit 7 Bit 6 Bit 5
- -
- Reference Selection
Description
*1
*1
*1
Terminals that Change depending on the Model of the Drive on page 55
Bit 4 Bit 3
Direction Fault Reset
-
Speed Reference (Low Byte)
YASKAWA SIEP C730600 84F DeviceNet Technical Manual
Bit 2 Bit 1 Bit 0
- Start Stop
- - -