CESSNA
MODEL 208B 867 SHP
GARMIN G1000
NORMAL PROCEDURES
ADF TEST (PREFLIGHT or IN FLIGHT):
1. ADF Button . . . . . . . . . . . . . . . . . . . . . . . . . . . . . SELECT ANT
2. ADF Button . . . . . . . . . . . . . . . . . . . . . . . . . . . . . SELECT ADF
Make sure pointer moves without hesitation to the station
bearing. Excessive pointer sluggishness, wavering or reversals
indicate a signal that is too weak or a system malfunction.
TO OPERATE BFO:
1. OFF/VOL Control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ON
2. BFO Button . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . PRESS ON
3. ADF Selector Button (on audio control panel) . . . . . . . . . . SET
4. VOL Control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ADJUST
A 1000-KHz tone and Morse Code identifier is heard in the
audio output when a CW signal is received.
TO OPERATE FLIGHT TIMER:
1. OFF/VOL Control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ON
2. FLT/ET Mode Button. . . . . . . . . . . . . . . . . . . . . . . . . . . . PRESS
Timer will already be counting since it is activated by turning the
unit on.
3. OFF/VOL Control . . . . . . . . . . . . . . . . . . . . . . . . . OFF then ON
FAA APPROVED
208BPHCUS-S9-00
SECTION 9 - SUPPLEMENTS
(Continued)
(mode and note pointer moves to 90° position)
NOTE
(once or twice until FLT is annunciated)
(if it is desired to reset the flight timer)
(Continued Next Page)
SUPPLEMENT 9
(to desired mode)
(to desired listening level)
U.S.
S9-9