Digital Wrench® Communication Errors; Digital Wrench® - Diagnostic Connector - Polaris RZR 570 2013 Service Manual

FUEL SYSTEM
7. Click on the link shown above, save the file to your
hard disk and then double-click the icon to start the
update process.
Do not "run" or "open" the file from where they are.
Select "save" and download them to your PC before
running the install.
8. When the update is complete, the version shown on
the right side of the Digital Wrench® start-up screen
should match the update you just downloaded.
Versions and updates are subject to change.
DIGITAL WRENCH® COMMUNICATION
ERRORS
If you experience problems connecting to a vehicle or
any Digital Wrench® related problem, visit the Digital
Wrench® Knowledge Base for the most current
troubleshooting information, FAQs, downloads and
software updates at: http://polaris.diagsys.com/.
4.40
NOTE
NOTE
DIGITAL WRENCH® - DIAGNOSTIC
CONNECTOR
Located under the hood connected to a sealed plug
Follow these steps to connect the diagnostic interface
cable to the vehicle to allow Digital Wrench® use:
1. Assemble the SmartLink Module and attach the PC
Interface Cable to your laptop.
2. Remove the protective cap from the Digital Wrench®
connector.
3. Connect the Vehicle Interface Cable to the Digital
Wrench® diagnostic connector.
4. Turn the ignition key to the 'ON' position, select the
appropriate vehicle and wait for the status to display
'Connected' in the lower left corner of the screen.
5. Once connected,
Wrench®.
9926813 R04 - 2013-2016 RZR 570 Service Manual
proceed with using
© Copyright Polaris Industries Inc.
q
.
Digital