Connecting Wired Zone And Siren - Visonic PowerMaster-33 G2 Installer's Manual

A. LINE
D. 8-position RJ-31X plug
B. SET
E. Brown
F. Red
C. RJ-31X cord
Phone wiring in the UK: Line terminals must be connected to pins 2 and 5 of the wall jack.
For all installations: If DSL service is present on the phone line, you must route the phone line through a DSL filter
See 2. CHOOSING THE INSTALLATION

3.4 Connecting Wired Zone and Siren

If an expander module is not installed, one wired zone and one low voltage siren can be connected directly to the front
panel PCB. Review Figure 3.1.1.or 3.1.2 and identify symbol "B".
A. GND
B. Wired Zone
C. Siren
D. For future
use
E. Site external
siren MG
electronics
MG441PDS
or equivalent
6-12VDC,
150 mA Max
F. Magnetic
contact or
any other
contact but
not a
detector
G. Alarm N.C.
3
Wired zones can be enrolled in any zone in the PowerMaster-33 G2 control panel from 01 to 64
D-306917
PowerMaster-33 G2 Installer's Guide
PHONE WIRING IN NORTH AMERICA
G. Green
H. Gray
I.
Figure 3.3b – Phone Wiring in North America
LOCATION, note about
3
WIRED ZONE &SIREN WIRING
Figure 3.4 – Wired Zone and Siren Wiring
RJ-31X jack
DSL filters for details.
J. Line from street
K. House phones
11