Installing An Optional X-10 Siren - Visonic PowerMax Pro Installer's Manual

Fully superviser wireless alarm control system
Hide thumbs Also See for PowerMax Pro:
Table of Contents

Advertisement

Front
unit
Back
unit

3.11 Installing an Optional X-10 Siren

If you need a "wireless" external siren, you may install an X-
10 siren module which is triggered by a signal transmitted
via the built-in electrical wiring of the protected site. This
siren can replace the regular external siren or complement it
without laying out additional wires. Of course, such a siren
can be used only in conjunction with an optional power-line
interface module.
The X-10 siren is ready to function upon connection to an
electrical
power
outlet,
PowerMax Pro. You only have to set the HOUSE CODE
and the UNIT CODE selectors on the X-10 siren as follows:
House Code: Set this selector to the letter that follows, by
alphabetical order, the letter that you programmed as a
house code for the protected premises. For example, if the
programmed house code is "J", set the siren house code
selector to "K".
Note: If the programmed house code letter is "P" (which is
the last programmable letter), select "A" for the siren.
Unit Code: The siren will function only if you set the unit
code selector to "1".
DE5468IP
2
Close the panel and
fasten the 2 screws.
Figure 3.1H - Final Closure
without
re-programming
Connect the flat cables in their respective
connectors (2 - 5, according to options).
3.12 Connecting to a Computer
The control panel can be equipped with an optional RS232
module for serial data interchange with a local computer. If
this module is not supplied, a special plastic cap blocks the
niche designed to accommodate the module.
Pull out the plastic cap (see figure 3.1I). Insert the RS-232
adapter and secure it with the screw. Break the smaller
section of the removed plastic cap and insert it back into its
place.
Front Unit
the
Figure 3.1
3.13 Connecting to GSM Modem
The GSM unit enables the PowerMax Pro system to
operate over a cellular network. For details regarding the
GSM modem features and connections, refer to the GSM
Modem installation instructions.
1
RS-232
Plastic
adapter
cap
RJ-45 or
RJ-31X
(USA)
I - Connecting to a Computer
9

Advertisement

Table of Contents
loading

Table of Contents