Installing An Optional X-10 Siren; Connecting To A Computer - Visonic POWERMAX PRO Installer's Manual

Front
unit
Back
unit

3.11 Installing an Optional X-10 Siren

If you need a "wireless" external siren, you may install an
X-10 siren module which is triggered by a signal
transmitted via the built-in electrical wiring of the protected
site. This siren can replace the regular external siren or
complement it without laying out additional wires. Of
course, such a siren can be used only in conjunction with
an optional power-line interface module.
The X-10 siren is ready to function upon connection to an
electrical power outlet,
PowerMax Pro. You only have to set the HOUSE CODE
and the UNIT CODE selectors on the X-10 siren as follows:
House Code: Set this selector to the letter that follows, by
alphabetical order, the letter that you programmed as a
house code for the protected premises. For example, if the
programmed house code is "J", set the siren house code
selector to "K".
Note: If the programmed house code letter is "P" (which is
the last programmable letter), select "A" for the siren.
Unit Code: The siren will function only if you set the unit
code selector to "1".
DE5468IP
2
Close the panel and
fasten the 2 screws.
Figure 3.1H - Final Closure
without re-programming
Connect the flat cables in their respective
connectors (2 - 5, according to options).

3.12 Connecting to a Computer

The control panel can be equipped with an optional
RS-232 module for serial data interchange with a local
computer. If this module is not supplied, a special plastic
cap blocks the niche designed to accommodate the
module.
Pull out the plastic cap (see Figure 3.1I). Insert the RS-232
adapter and secure it with the screw. Break the smaller
section of the removed plastic cap and insert it back into
its place.
the
Front Unit
Figure 3.1 I - Connecting to a Computer
1
RS-232
Plastic
adapter
cap
RJ-45 or
RJ-31X
(USA)
9