Brake Fluid Reservoir; Brake Hose Replacement - Club Car XRT 950 2009 Maintenance And Service Manual

BRAKES

BRAKE FLUID RESERVOIR

802
Figure 6-2 Brake Fluid Access
The brake fluid reservoir (5) is located under the hood and under the round access panel (Figure 6-2). Raise the hood
and remove the round access panel to check the brake fluid level.
During the brake fluid level inspection, also inspect the following:
• The presence of brake fluid on the exterior surface of the master cylinder indicates a leak.
• The brake fluid reservoir diaphragm (located in the cap) should not have holes or other damage.
Brake Fluid
Brake fluid level should be within 1/4-inch (6 mm) from the top of the reservoir (Figure 6-3). Also, brake fluid should be
clean with no residue in the bottom of the reservoir or other evidence of contamination.
CAUTION
• Use only DOT 5 (silicone) brake fluid. Use of any other type brake fluid is not recommended.

BRAKE HOSE REPLACEMENT

See General Warning on page 1-2.
WARNING
• To perform any of the following procedures, the hydraulic system must be opened. As a result, the
brakes must be bled after the correct reinstallation of the brake components. Failure to bleed the
brakes could result in decreased braking performance due to air being trapped in the hydraulic
system. Use only DOT 5 brake fluid. See Bleeding the Hydraulic Brake System on page 6-16.
• Prior to servicing hydraulic brakes, thoroughly clean the vehicle, paying particular attention to areas
immediately surrounding hydraulic connections, to prevent dirt or debris from entering system.
NOTE: The brake hoses are provided as assemblies without separating unions other than those at the wheels and
master cylinder.
Hydraulic and Mechanical Components
1. Full Level 2. Safe Level 3. Low Level
803
Figure 6-3 Brake Fluid Reservoir
2009-2012 XRT 950 Maintenance and Service Manual
6
1
2
3
Page 6-7