Table of Contents
Advertisement
17
Rear Axle Tubes, Axle Shafts and Wheel Bearings
2215
Figure 17-18 Rear Wheel Bearing
REAR WHEEL BEARING INSTALLATION
1.
Clean inside axle tube (1) where new bearing will sit and lightly lubricate the bore with anti-seize compound
(Figure 17-18, Page 17-18).
2.
Using an appropriate sized bearing driver that fits the outer race, drive in new bearing (3) until fully seated.
3.
Install retaining ring (2).
4.
Clean axle shaft and carefully install axle tube (1) to avoid damaging new seals. See Rear Axle Tube and
Axle Shaft Installation on page 17-17.
Page 17-18
2016 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual
1
DRIVETRAIN COMPONENTS
Advertisement
Table of Contents
Troubleshooting
