Replacing The Combiner And Radiator Module - Christie HS 2K Series Service Manual

10. Remove the light engine.
See Replacing the light engine
11. Remove the DMD board.
See Replacing the DMD board
12. Release the DMD socket securing the DMD.
13. Replace the DMD.
When replacing the DMD module ensure that the new thermal pad is applied evenly.
14. To re-install, follow these steps in reverse order.
Replacing the combiner
Replacing the combiner and radiator module must be done in a clean room.
To remove the combiner and radiator module, complete the following steps.
1. Remove the top cover.
See Removing the top cover
2. Remove the main board module.
See Replacing the main board
3. Remove the main board bottom shielding.
See Removing the rear cover
4. Remove the rear cover.
See Removing the rear cover
5. Remove the I/O board.
See Removing the I/O board
6. Remove the front cover.
See Removing the front cover
7. Remove the left-side cover.
See Removing the left-side cover
8. Remove the right-side cover.
HS Series 2K Service Manual—DWU1612-HS, DWU2022-HS
020-001790-01 Rev. 1 (03-2020)
Copyright ©2020 Christie Digital Systems USA Inc. All rights reserved.
on page 85.
on page 105.
and radiator
on page 59.
on page 94.
on page 59.
on page 59.
on page 99.
on page 61.
on page 63.
Optics
module
89