Christie HS 2K Series Service Manual page 101

1. Remove the top cover.
See Removing the top cover
2. Remove the main board module.
See Replacing the main board
3. Remove the main board bottom shielding.
See Removing the rear cover
4. To separate the affected laser driver board, remove the corresponding two M3 screws with a
Phillips #1 screwdriver.
5. Remove the harnesses from the clips.
6. On the laser driver board, unplug the six connectors.
HS Series 2K Service Manual—DWU1612-HS,DWU2022-HS
020-001790-01 Rev. 1 (03-2020)
Copyright ©2020 Christie Digital Systems USA Inc. All rights reserved.
on page 59.
on page 94.
on page 59.
To LVPS
To TEC
Printed circuit boards and sensors
To BLD
To mian board
101